Part Of Maintaining Your Car Is Using Windshield Washing Fluid

Windscreen washer fluid is an important part of maintaining your car. Most commercial leather conditioner contain a poisonous chemical dangerous even in small amounts.[1] Because of methanol’s danger to both health and the environment, some people elect to make their own methanol-free windshield washing fluid at home. Custom washing fluids are also easy to make out of ordinary household ingredients and save money in the long run.

Add one gallon of distilled water to a clean, empty container. Pick a container that is easy to pour and holds at least one and a quarter gallons. Always use distilled water to prevent mineral deposits from building up in your car’s spray nozzles and pump. Tap water can be used in an emergency.

Just remember to replace the fluid as soon as possible to keep from damaging your car.

Add one cup of glass cleaner. Pick the commercial glass cleaner of your choice. Make sure to choose a cleaner that produces minimal (preferably no) suds or streaks. This method is good for everyday use, especially during the summer.

Mix well by shaking the container and add the solution to your car. If this is your first time making it, test it on your car first. Dab a little solution onto a rag and wipe a corner of the windshield. The ideal cleaner should wipe away dirt without leaving any residue.

Add one gallon of distilled water to a clean jug. Use a funnel if you have difficulty adding the water. The jug should be easy to pour and capable of holding a little over a gallon. Be sure to save the container’s cap for easy mixing and storage.

Measure one tablespoon of dish soap and add it to the water. Don’t use too much soap, or your washing fluid may be too thick. Use whatever kind you have on hand. Make sure the soap doesn’t leave behind streaks or residue on glass.

If it foams too much, try a different soap.

Add 1/2 cup ammonia. Use a non-sudsing ammonia that is free from additives and surfactants. Be very careful with this step, as concentrated ammonia can be dangerous. Work in a well-ventilated area and wear gloves.[3] Once the ammonia is well-diluted by the water, it becomes relatively safe for use as a cleaner.

Recap the container and shake to mix well. Test your cleaner before using it for the first time. Dab a little onto a clean rag and wipe a corner of your windshield. If your cleaner removes grime without leaving a residue, it’s ready to put in your car.

Add one cup isopropyl (rubbing) alcohol to any of the first three methods if temperatures drop below freezing. If your winters are mild, use 70% rubbing alcohol. If you experience extreme cold weather, use 99% instead.

Leave a small container of your solution outside overnight. If the fluid freezes, you will need to add at least another cup of alcohol. Test your solution again. This step is very important to prevent the fluid from freezing and rupturing your car’s washer fluid hose.

Mix thoroughly by shaking the container. Drain any warm weather washing fluid before adding the cold weather cleaner. If there is enough warm weather fluid left, it may dilute the alcohol in the cold weather cleaner. If the alcohol is diluted enough, the solution will freeze.

Pour 12 cups (3/4 gallon) distilled water into a clean, empty jug. Make sure the container’s capacity is a little more than a gallon. If the rim of the container is narrow, use a funnel to make pouring easier. Label your container with a permanent marker.

Add 4 cups white vinegar. Use white vinegar only. Other types of vinegar may leave behind residue or stain your clothing. This is the best type of cleaner for removing pollen.

Do not use this method in warmer weather. Hot vinegar creates a foul, pungent odor.

Mix the solution thoroughly by shaking the container. If the temperatures in your area dip below freezing, do a freeze check before adding the cleaner to your car. Leave a small cup of the solution outside overnight and check in the morning. If it has frozen, add another two cups of vinegar to the jug and try again.

If it still freezes, add one cup of rubbing alcohol and check again. Community Q&A Search Add New Question If my owner’s manual tells me not to use anything but commercial washer fluid and that homemade washer fluid can damage the paint or washer fluid pump, is the solution in this article safe?

Yes No Not Helpful 0 Helpful 5 Can you add 90% rubbing alcohol to windshield washer fluids to keep it from freezing? In fact, it is the preferred method. How much to add depends on your climate. The more isopropanol (rubbing alcohol) you use, the lower the freeze point. Normally this type of alcohol is readily available in the pharmacy in 70% and 91% solutions.

The cost per ounce of pure alcohol is almost exactly the same, so use the 91% for easier mixing of ratios. It’s not possible to suggest a ratio of alcohol to water, since that depends on your climate. The last thing you want is for the fluid to freeze and burst the fluid reservoir, so more is better––up to 50% in extreme situations. Stay away from vinegar and ammonia because this fluid touches the paint and can cause problems. Yes No Not Helpful 7 Helpful 14 The windshield has streaks that have been etched by salt in the air.

Can I get rid of these streaks? The etches from any mineral harder than polycarbonate are permanent. You can either dissolve the polycarb with an acetone (which also leaves a mark), or get a new windshield. If it was a crack or chip, it could be filled, but scratches require major surgery. Yes No Not Helpful 8 Helpful 12 How can I get the bad odor and streak marks caused by human urine off the windshield of a car? Then, take some 0000 steel wool and clean the windshield with it. Make sure you only use 0000 steel wool. Yes No Not Helpful 9 Helpful 8 Will using the ammonia or rubbing alcohol mixtures cause possible paint damage over time? These chemicals are similar to “acid rain.”

If the chemicals stay on the painted surface for any period of time, they will etch the surface and cause what many refer to as “water spots”. The good news is, if you already have these spots, any good detail shot shop can buff them out for you, if the damage is not too severe. Never let these chemicals stand on a freshly painted surface or in direct sunlight, as they may become permanent. Yes No Not Helpful 2 Helpful 0 Unanswered Questions Will vinegar cause paint damage over time?

Answer this question Flag as Flag as Show more unanswered questions Ask a Question 200 characters left Submit Already answered Not a question Bad question Other If this question (or a similar one) is answered twice in this section, please click here to let us know. Tips Topping off windshield washer fluid is easy. Simply open the hood and find the windshield wiper fluid reservoir. It will be a large, square white or clear tank towards the front of the car. Most have a simple flip cap that you can easily remove without tools. Use a funnel when adding fluid to prevent spillage. If you are switching from a warm weather fluid to a cool weather one, be sure to drain most of the remaining warm weather solution. The safest way to do this if the original fluid contains methanol is to siphon it off with a turkey baster. Plain water can be used alone as a substitute in an emergency.

However, water will not clean as well. Additionally, it can serve as a breeding ground for dangerous bacteria.[6] Recycle empty milk, vinegar, and laundry detergent jugs to make and store your cleaner. Be sure to rinse them thoroughly before use. Clearly label your washing fluid, especially if you’re reusing a container. You can also dye it with blue food coloring to make it look like commercial cleaner.[7] While these homemade cleaners are less dangerous than methanol, they can still be harmful if swallowed. Be sure to keep the mixture out of reach of animals and children.

Always use distilled water when making windshield wiper fluid. Minerals in tap water can form deposits that will eventually clog your vehicle’s spray nozzles and pump. Don’t mix vinegar and soap. They can react together and curdle, clogging your hose.[8] These solutions can be used as all-purpose surface cleaners for windows and the rest of your car.